Author Topic: Another question about poly reversibles  (Read 406 times)

Offline Scobey Peterman

  • Sr. Member
  • ****
  • Join Date: May 2009
  • Posts: 369
  • Liked: 0
Another question about poly reversibles
« on: November 01, 2009, 05:15:40 PM »
This is for the same order as I have posted before. My next question what mesh count to use. A4 says 86 to 110. I can do either one. What do you suggest on tha automatic??


Thanks again ;D
Quality over Quantity


Offline killergraphics

  • Administrator
  • Top Member
  • *****
  • Join Date: Jan 2007
  • Posts: 4,371
  • Liked: 46
    • http://www.myTguys.com
  • State: Tennessee
Re: Another question about poly reversibles
« Reply #1 on: November 02, 2009, 06:09:34 AM »
You know on our Browns we do not have the control of the ink like we should, but I would go a double 110 or 158 and adjust the squeegee angle at about 40 or 45 degrees.

If you run into problems with them staying tacked to the table for the double hit. Slow the print stroke down and try a one hit, then you might want to try a 86.

So yes I don't know ;)
Life is a hel!-of-a thing to happen to a person.
Just remember do the best you can and there is no such thing as a loyal customer.

www.myTguys.com
www.killergraphics.net
www.USArmyonly.com

If you see a turtle on a fence post...you can bet he had help getting up there. :)
                                                                                     Little Jimmy Dickens

Offline SBrem

  • Top Member
  • *****
  • Join Date: Aug 2008
  • Posts: 1,598
  • Liked: 5
    • http://imprintgraphics.com
  • State: Massachusetts
Re: Another question about poly reversibles
« Reply #2 on: November 02, 2009, 07:58:57 AM »
Sefar has a mesh, 81SDE, that will lay down what you want with one stroke. It's an 81 mesh, but with a fine thread. It kind of simulates the old XX multifiliments, but much tougher. It has a larger percentage open area due to the thinner threads. Murakami makes a 110s, which is a similar idea, higher percentage open area with the same stencil control. It's the only 110 we use, check it out, you may like it. (we've done a zillion of those shirts, I think you'll like the result.)

Steve
Life's a load; you're either pulling it, pushing it, or it.


 

Site Meter SPOF
Copyright 2007-2011 Screenprintersopen.com